Forgot password

Bulkhead glassing to hull

  • February 08, 2013 12:12 AM
    Quote
    Message # 1202382
    Anonymous member

    On bulkhead, have any of you reworked some of the bulkheads and glassed them to the hull...? Have you placed foam between the bulkhead and hull or held the bulkhead uniformly off the hull and filled the space with resin / micro ballon mix, and made a fillet, then glassed ...? Or just placed the bulkhead directly on the hull...? All this addresses Hard spot issues...? But our hulls are so thick that this may not really be a problem....? Any input..... The ones that I am referring to support the I beam and compression post...
  • February 09, 2013 7:10 PM
    Quote
    Reply # 1203755 on 1202382
    Anonymous
    Whenever I have reinforced anything in my vessel, I have used Kyntex biaxial fabric. Years ago, I purchased a roll (about 8" wide) of this fiberglass tape from Tap Plastics. Gougeon Brothers/WestSystems has plenty of information on using their products to apply this tape to reinforce bulkheads, etc.
  • February 10, 2013 8:33 AM
    Quote
    Reply # 1204008 on 1202382
    Anonymous member

    I put my two cents into this in the Ask Bud section. 

    But again, Westsail always used a foam fillet on the edge of the three main structural bulkheads.  It is not necessary for the furniture bulkheads because they do not go across the hull..  An angular filet between the plywood face and the hull on the rest of the bulkheads is good so the fiberglass lays in well and is easier to wet out with resin.
Powered by Wild Apricot Membership Software