exhaust elbow perkins 4-108

  • July 04, 2016 2:16 PM
    Message # 4114654

    Please look under my profile pictures to see what I'm writing about.

    I'm trying to source a replacement exhaust elbow for my Perkins 4-108.

    It was a cast piece that has corroded and no water flow thru it from heat exchanger into the exhaust stream...almost over heated my engine... :-(

    I've found a couple stainless steel ones online but they aren't cheap though I'm wondering if in the end if one of these would be the best choice since it should last a long time???

    Any help is appreciated.

    Ben

  • July 04, 2016 2:59 PM
    Reply # 4114676 on 4114654
    Anonymous member (Administrator)

    Ben:  I think that I see a rusted out (galvanized) coupling between two cast fittings?

    Are the two cast pieces OK?

    Jay

    Last modified: July 04, 2016 3:01 PM | Anonymous member (Administrator)
Powered by Wild Apricot Membership Software